Autel MaxiTPMS TS508 Complete Guide

0 comments

The MaxiTPMS TS508 is a new generation TPMS diagnostic & service tool specially designed to activate all known TPMS sensors, read TPMS sensor status, check TPMS system health condition, program MX-sensors and conduct TPMS relearn. With Quick Mode and Advanced Mode options, you can save time and energy by choosing the most suitable way to complete TPMS work. TS508K, the starting TPMS kit with one tool and 8 sensors, can be your right choice to experience AUTEL TPMS lines.

Autel TS508 Advanced Features:

Two TPMS Service Modes

TPMS Quick Mode: basic TPMS functions to check TPMS sensors and program MX-Sensors quickly;

  •  Scan Sensor & Vehicle Identification
  •  Activate All the TPMS Sensor
  •  Relearn Sensor: Automatic Relearn
  •  Program Sensor: Copy by Activation, Copy by Manual Input, Auto-Create
  •  Sensor Information: Sensor ID, Frequency, Voltage, Hardware Version, OE Manufacturer, etc

TPMS Advanced Mode: complete TPMS functions to perform sensor check , TPMS diagnose, MX-Sensor program and sensor position relearn.

  • TPMS Diagnostics: Check TPMS and Sensor State, Trigger Sensors, Read/Erase DTCs, Re-check ECU, Turn off the Light
  • Program Sensor: Copy by OBD, Copy by Activation, Copy by Manual Input, Auto Create
  • Position Relearn: OBD Relearn, Automatic Relearn, Stationary Relearn
  • Information: OE Sensor and MX-Sensor Information, OBD2 Port Location
  • Read/Write Tire Type and Tire Pressure

Four MX-sensor Programming Options

Copy by Activation: If the old sensors are not completely broken, you can activate or trigger the old sensors and retrieve the old ID, and then write it into the new MX-Sensors. The new MX-Sensors can be replaced directly in the original position without relearning.

 Copy by Manual Input: If the original sensor is completely bad or can’t be activated, you can find the old ID from the cover of the old sensors, and manually input the old sensor ID to new MX-Sensors.

 Auto Create: If the old sensor is completely broken or the original sensor ID can’t be obtained, you can use the TS508 TPMS programming tool Auto create new unique ID(s) to 1-16 MX-Sensor(s).

 Copy by OBD: Compared to Autel TS408 & TS401, TS508 can read/clear TPMS DTCs and has an OBD2 connector. You can connect the OBD cable and read ECU information to receive the old sensor data like sensor ID previously stored in TPMS ECU module and copy it to MX-Sensors.

TS508 3 TPMS Relearn Ways

OBD Relearn: 56% of Users’ Choices>>OBD relearn allows the TS508 TPMS relearn tool to directly write the TPMS sensor IDs to the TPMS module via the OBD connector to make the on-board TPMS modules recognize the new sensors. That is so convenient! (Note: TS401& TS408 not available with OBD Relearn)

Automatic Relearn: 38% of Users’ Choices>>For some vehicles, the “Relearn” function can be completed automatically by driving, which makes it quite easy to do a complete set of sensor replacement operations on your own.

Stationary Relearn: 18% of Users’ Choices>> This relearn way requires the vehicle to be placed in the “Learn Mode” and follow the instructions to finish “Relearn”.

Leave a comment

All blog comments are checked prior to publishing
    You have successfully subscribed!
    This email has been registered
    ico-collapse
    ic-cross-line-top
    Top
    ic-expand
    ic-cross-line-top